1 Topic by brandon

  • brandon
  • Member
  • Offline
  • Registered: 2014-12-21
  • Posts: 87

Topic: Help with ordering a part

I am going to bite the bullet and order a E3D v6.  However I believe that I will still need the filament feeder assembly replaced.  Does anyone have a suggestion on where to get one?  They used to have replacements on the SD website but no longer.

2 Reply by jagowilson

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: Help with ordering a part

You can get them from filastruder. http://www.filastruder.com/products/law … solidoodle

3 Reply by brandon

  • brandon
  • Member
  • Offline
  • Registered: 2014-12-21
  • Posts: 87

Re: Help with ordering a part

Bless you.  That was seriously stressing me out.  thanks!

4 Reply by aecarver

  • aecarver
  • Member
  • Offline
  • Registered: 2014-08-25
  • Posts: 24

Re: Help with ordering a part

If your printer isn't out of commission, you can also print those.  They're available on thingiverse.

5 Reply by brandon

  • brandon
  • Member
  • Offline
  • Registered: 2014-12-21
  • Posts: 87

Re: Help with ordering a part

Yes, that's where I found it but my printer is basically a paperweight until (hopefully) I get those new parts.

6 Reply by brandon

  • brandon
  • Member
  • Offline
  • Registered: 2014-12-21
  • Posts: 87

Re: Help with ordering a part

The link was to the MK5 which I wound up buying.  Does anyone know if it will work with the E3D hotend?

7 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Help with ordering a part

If you bought it form filastruder it will fit your V6.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website