1 Topic by rcskpeters

  • rcskpeters
  • Member
  • Offline
  • Registered: 2014-12-27
  • Posts: 28

Topic: Slic3r help

I made 2 prints today use the models from Make magazine used to test the printers. I ran one through the XYZ software and one through slic3r using similar settings. The XYZ print came out looking better. The one on the right was from slic3r. I have them both set at .2mm, 10% infill. I'm not sure what the speed differences are but XYZ was set at normal speed and slic3r was set at 40 mm/s. XYZ used the default of 220 temp for the extruder and I had slic3r set at 210.

Any help on understanding why such a difference in prints would be greatly appreciated. The print from slic3r also came out with ABS strands coming off 2 corners.

Thanks!
Ryan

Post's attachments

WP_20150118_17_08_45_Raw.jpg
WP_20150118_17_08_45_Raw.jpg 631.03 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.