Topic: Does one need to flash the board if
They get a volcano hot end?
Also how does that work with slic3r. All I've seen is .4 mm as being the highest
- AZERATE
- PRINTiT
- Offline
Re: Does one need to flash the board if
Flash firmware? Nope!
Play with the settings a bit? Yup!
If you have already installed the E3D v5/v6, and you have flashed the firmware for that already, then the Volcano is a plug and play.
Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!
Re: Does one need to flash the board if
What about the .4 mm being the highest it lets you do? Double the multiplier?
AZERATE wrote:
Flash firmware? Nope!
Play with the settings a bit? Yup!If you have already installed the E3D v5/v6, and you have flashed the firmware for that already, then the Volcano is a plug and play.
- wardjr
- Moderator
- Offline
Re: Does one need to flash the board if
Firmware has nothing to do with that. Change it in Slic3r and your good.
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
Re: Does one need to flash the board if
My volcano hot end will be here Monday. Can't wait to run some prints with it. But I'm still curious about what settings I need to change in slic3r