1 Topic by takadakeyo

  • takadakeyo
  • Member
  • Offline
  • Registered: 2014-06-29
  • Posts: 149

Topic: SD3 Holes in my finished prints?

Hello,
So I noticed on most of my prints (8 out of 10) there will be holes in my prints. Not a huge deal since I can fill and sand them, but still would be nice to not have holes. haha

This is what it looks like

http://i250.photobucket.com/albums/gg272/Taiy4ki/20150112_133858.jpg

http://i250.photobucket.com/albums/gg272/Taiy4ki/20150112_133908.jpg

Im no a pro and just started, so please forgive me lack of knowledge. But maybe its my settings in Slic3r? so here is the settings i think might need changing.

http://i250.photobucket.com/albums/gg272/Taiy4ki/1-2.jpg

http://i250.photobucket.com/albums/gg272/Taiy4ki/2.jpg

Any help would be appriciated

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: SD3 Holes in my finished prints?

This appears to be under extrusion, have you calibrated the steps/mm or the extrusion multiplier?
What kind of results do you get when printing at .3 layer height?

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website