1 Topic by KevlarGorilla

  • KevlarGorilla
  • Member
  • Offline
  • Registered: 2013-11-16
  • Posts: 19

Topic: Repetier-Host 1.0.6 setup

I've tried on two occasions to get my printer to work with RH above 1.0, but I can't seem to get the software to see the printer at all. I know I'm missing steps, and I can't find any resources.

Is there a detailed step-by-step guide anywhere that can help me install this new version?
Is there a build or package that has a Solidoodle 3 in mind?

-SD3, E3Dv5, boz's E3D extruder, ABS from Sainsmart, mirror bed + dried hairspray + ABS slurry
-KevlarGorilla's 8x bearing threadless ball screw, 2n2r5's spring'd bed stabilizer
-fts_ltx's x-carriage, lawsy's v5 y-axis carriages, 2n2r5's beltless drive
-Overhead filament holder on 8mm rod, custom fillament feed, paeltz's simple enclosure, mini heater (opt)

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Repetier-Host 1.0.6 setup

Did you double check you have the right COM port under Printer Settings?
I think I remember having to re-select the port after my upgrade.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by puncture

  • puncture
  • Newbie
  • Offline
  • From: Ohio
  • Registered: 2013-11-17
  • Posts: 4

Re: Repetier-Host 1.0.6 setup

Yeah, I had a similar problem. Had to go to config, printer settings and change mine to COM4. Just had to check my old solidoodle build of repetier to find the port number.