1 Topic by mwille

  • mwille
  • mwille
  • Member
  • Offline
  • From: Southeast Kansas
  • Registered: 2014-10-12
  • Posts: 55

Topic: Does room temp affect printing?

I've started thinking about where to put my printer (SD Press) when it finally arrives.  The main things I've come across in my reading is that it's best to be away from drafts if possible, and to keep in mind possible harmful effects of fumes. 

I was thinking about having it in my utility/laundry room.  The thing is, I don't keep it at normal room temp to save on the utility bill.  In the winter it is probably 50-60 (F), and summer possibly as high as the 90s (F). 

Do any of you have experience printing in similar environments? 
Would it be better to find a spot in a more climate controlled area?

SD Press
Modeling software: 123D Design

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Does room temp affect printing?

I don't think you need to worry about climate as you do with moisture.
The Press is already enclosed, so the heat the bed and hotend produce inside the chamber will fight ambient temps. My basement is in the same area as yours, and my enclosure has some openings.

Moisture will ruin your filament though.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: Does room temp affect printing?

I always preheat the bed for about 15 minutes before I start to print.

Ultimaker S3.

4 Reply by wire10ga

  • wire10ga
  • wire10ga
  • Member
  • Offline
  • From: Arkansas
  • Registered: 2012-09-14
  • Posts: 665

Re: Does room temp affect printing?

dubbsd wrote:

I always preheat the bed for about 15 minutes before I start to print.

+1

SD2 - Glass Bed, Fans on PCB and Y motor, Custom enclosure
Slicer - Simplify3D

wire10ga's Website