1 Topic by HaroldDavid

  • HaroldDavid
  • Newbie
  • Offline
  • Registered: 2014-01-05
  • Posts: 5

Topic: Print stops halfway

Hi , I am recently experiencing this problem where my printer stops during the print. The extruder remain at the place where it stopped and the logs on the Repetier host shows: 18:06:46.496 : Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting). By the way, I also tried using Cura and it has the same problem. Please help. Thank you.

2 Reply by IronMan

  • IronMan
  • IronMan
  • PRINTiT
  • Offline
  • From: SC
  • Registered: 2012-09-14
  • Posts: 1,269

Re: Print stops halfway

Check your hot end thermistor wiring...check for shorts / loose connections.  Also, make sure the wiring is secured properly and does not flex with movement of the carriage.

SD2 - Stock - Enclosure - Heated Bed - Glass Plate - Auto Fire Extinguisher
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Print stops halfway

IronMan wrote:

Check your hot end thermistor wiring...check for shorts / loose connections.  Also, make sure the wiring is secured properly and does not flex with movement of the carriage.

Yep

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

4 Reply by HaroldDavid

  • HaroldDavid
  • Newbie
  • Offline
  • Registered: 2014-01-05
  • Posts: 5

Re: Print stops halfway

Hi, I checked every connection, everything is fine, I used another USB cable, USB PC port and even used another PC, nothing works

5 Reply by IronMan

  • IronMan
  • IronMan
  • PRINTiT
  • Offline
  • From: SC
  • Registered: 2012-09-14
  • Posts: 1,269

Re: Print stops halfway

Same is true for the heat bed thermistor...check all those connections as well from the thermistor leads all the way back to the controller board.

SD2 - Stock - Enclosure - Heated Bed - Glass Plate - Auto Fire Extinguisher
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!