1 Topic by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Topic: SD3 stopped mid print now I have problems

bed wont heat but to 47 C, extruder wont get to but 120 C. LED lights wont work. Did my board fry?

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: SD3 stopped mid print now I have problems

We need a bit more info. But the fact that it IS heating and and lights work is a good sign. Are you able to move the motors? If so, it is most likely due to a failing PSU. What type of board do you have? And what, if any, mods have you done lately?

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Re: SD3 stopped mid print now I have problems

I restarted the computer and it went back to working fine. So weird. It stopped due to a stupid update notification

AZERATE wrote:

We need a bit more info. But the fact that it IS heating and and lights work is a good sign. Are you able to move the motors? If so, it is most likely due to a failing PSU. What type of board do you have? And what, if any, mods have you done lately?

4 Reply by jagowilson

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: SD3 stopped mid print now I have problems

Thus the reason for this question smile