Topic: Electrical help
Where does this yellow plug in go?
Re: Electrical help
Did you intend to attach an image?
If you build it they will come. Then they will make fun of it, tell you it's not worth doing and go home and try to copy you.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.
Re: Electrical help
Yes. I'll try it again.
Re: Electrical help
I guess I can't get it to upload. It's the wire for thermister. I don't remember where it plugs into and cannot find any place that it fits.
Re: Electrical help
Looking at the PID diagram it would appear to be Pin 3 & 4. Look on page 9 of 11.
If you build it they will come. Then they will make fun of it, tell you it's not worth doing and go home and try to copy you.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.
Re: Electrical help
I have a pre-assembled kickstarter unit so it is a little bit different than the current manual. It has two pins that cannot be screwed into the terminals. Maybe I need to have so many posts to post a photo.
Re: Electrical help
.
Re: Electrical help
Re: Electrical help
There we go.
Re: Electrical help
There's no photo attached.
There's two terminals for the thermocouple on the PID unit, they should be labeled as such. Pins 7 and 8 on the Mypin controller, mind the polarity though.
I'm confused though - if you have an assembled unit, wasn't the thermocouple connector already installed? If you're asking because you disassembled it, then why not just put it back where you found it?
Re: Electrical help
I wasn't going to go there, but.............
If you build it they will come. Then they will make fun of it, tell you it's not worth doing and go home and try to copy you.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.
If a picture is worth a thousand words then being there is worth a thousand pictures.
(2) Stock Makerbot Z18s, Filastruder w/Melt Filter, Filawinder, Autodesk Inventor Design Suite 2014 .........so far.