1 Topic by Qvims

  • Qvims
  • Newbie
  • Offline
  • Registered: 2014-02-27
  • Posts: 9

Topic: Quick question! What is the default Z eestep on the solidoodle 4?

Is this the same as the solidoodle 3, I updated my firmware and could only find the firmware for SD3, is the treated rod the same as the one on the Sd3?

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Quick question! What is the default Z eestep on the solidoodle 4?

I don't know that they changed it, is it 5/16 rod? Then it's the same.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website