1 Topic by damas_j

  • damas_j
  • Member
  • Offline
  • Registered: 2013-11-25
  • Posts: 42

Topic: Infill is not regular

Hi,

I try to print a large object on my SD2 Pro.
The first 20 layers are excellent and the perimeters too. But after 20 layers, the infill deposit is not regular and become messy.

I have attached a picture.

Thank you for your help

Post's attachments

photo 2-1.JPG
photo 2-1.JPG 1.85 mb, 2 downloads since 2014-08-15 

You don't have the permssions to download the attachments of this post.

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Infill is not regular

Sounds like you have a partial clog.
Are you sure the filament and nozzle settings in Slicer are correct?

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Infill is not regular

Or you have some serious moisture in your filament along with your clog.
Summer time is hard on filaments and it seems as though we see a lot of clogging of nozzles this time of year.
Coincidence.... I think not.  Either way clean out that nozzle as best you can and try and dry your filament.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

4 Reply by damas_j

  • damas_j
  • Member
  • Offline
  • Registered: 2013-11-25
  • Posts: 42

Re: Infill is not regular

Hi thanks for your help.

What should be the correct setting in Slic3r? I use the 0.1mm default setting

5 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Infill is not regular

Start out with .3 settings once you have that mastered migrate to .1 if you feel the need.
As far as settings go what have you done as far as calibrations go.  That should be your first priority.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website