1 Topic by BFresh

  • BFresh
  • BFresh
  • Member
  • Offline
  • Registered: 2013-03-11
  • Posts: 118

Topic: 2 printers 1 PC

To save space, would it be possible to run 2 printers from 1 PC?

Obviously if you tried to slice a part whilst also trying to print a part, this would cause problems.

But could you just have 2 instances of RH open to run 2 different gcodes at the same time?

Industrial Designer
Fresh Design Works (UK)
www.freshdesignworks.co.uk

BFresh's Website

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: 2 printers 1 PC

Yep, I do it all the time.  You are correct about slicing though.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website