Topic: Fix Z Screw
I fix in my Solidoodle 2 Pro the bad z screw. I used a bolt and two nuts. I don't use a glue with nuts, but you can try it.
Solidoodle 2 Pro + Glass Bed
Re: Fix Z Screw
Print another screw mount before that one breaks, because it will. Don't end up like me. That is all.
SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed
- grob
- Member
- Offline
Re: Fix Z Screw
mdrVB6 wrote:
Print another screw mount before that one breaks, because it will. Don't end up like me. That is all.
Ouch, that would have been annoying. How did you print a new one - blue tak in place for the one print?? 
This is what this forum is for, first-hand advice. 
SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi
Smoothieboard via Octoprint on RPi
Re: Fix Z Screw
I had to have a guy I know print one and mail it to me. Lost a couple days.
SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed
- AZERATE
- PRINTiT
- Offline
Re: Fix Z Screw
mdrVB6 wrote:
I had to have a guy I know print one and mail it to me. Lost a couple days.
That's why I print like 5 of each replacement part. I take up more space in printed parts than all my spools....at lease the wife is cool with it
Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!