1 Topic by paramite12

  • paramite12
  • Member
  • Offline
  • Registered: 2013-01-19
  • Posts: 44

Topic: Retraction settings

I'm getting problems with blobs on my prints. I've been messing with the retraction settings and have minimized it a bit, but it's still not where I want it to be. What are the settings you guys are using? I use slic3r btw.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Retraction settings

1 to 2 mm at 70mm/s

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by Damon550

  • Damon550
  • Member
  • Offline
  • From: tasmania Australia
  • Registered: 2013-05-06
  • Posts: 107

Re: Retraction settings

0.5mm with completely dry abs otherwise i have to go up to 1mm when its damp