51 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: upgraded SD3 with E3D and Lawsy's LM8UU carriage... I have a question:

Is there a chance you have two versions of arduino installed?  Sounds like you need to locate that folder and get it into the hardware folder of the arduino your running.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

52 Reply by accusedmonk

  • accusedmonk
  • Member
  • Offline
  • Registered: 2013-10-22
  • Posts: 253

Re: upgraded SD3 with E3D and Lawsy's LM8UU carriage... I have a question:

I really like that setup Bookmaker.  I most likely would have done something similar for mine, but I don't have the shop equipment for metal yet.  We all have quite unique printers!

Bowden SD3, Rumba, E3D hotend, Mk5 with RtRyder changes, Direct drive Y axis and bearings, GT2 pulleys and braided fishing line, Lawsy linear bearing conversion, M3 Z screw.