1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: dead printrboard

I noticed  that the led strip was off and then looked at the extruder fan, it was off also,Then I went voltage hunting.
I have 12v going to the connector but on the board side nothing.Something is killing the voltage. The green led is on when the usb is connected tho.FYI its a Printrboard revE. Dead board? Odd tho as it was printing an hour ago.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: dead printrboard

Dead connector, not board.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend

3 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: dead printrboard

thanks , that was it is. I bypassed  the connector and it works, Now to find a connector like that.,lol I'll just Mcgever it for now.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.