1 Topic by Snape99

  • Snape99
  • Newbie
  • Offline
  • Registered: 2014-02-14
  • Posts: 5

Topic: Slic3r setting help!!!!

I have been noticing that lately, my parts that i have printed are rather unsteady, i figured this is because of the settings and how much space there is in-between lines, please help!!!!!

Post's attachments

photo-2.JPG
photo-2.JPG 1.48 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by driggers

  • driggers
  • Member
  • Offline
  • Registered: 2012-10-07
  • Posts: 162

Re: Slic3r setting help!!!!

Are those lines supposed to make a solid layer?

If so, try increasing the flow rate (e.g. with extrusion multiplier), or going through some calibration steps.

http://solidoodletips.wordpress.com/201 … flow-rate/

http://www.alejandroerickson.com/home/eggs/imrep/extrusion_multiplier.png

SD2 Sanguinololu 1.3a atmega1284p, wood platform, lawsy's carriages, braided fishing line, pallet wood overhead spool mount, carboard/magnet enclosure, glass bed, E3D v6, bed levelling knobs, extended z-stop, 25A DC-DC SSR for bed heater, everything fixed to the SD2 frame, marlin firmware with some adjustments and extra failsafes enabled.  I'll never give up on you, little printer that could(n't)!