Re: Best way to get rid of z-wobble?
So I have the mod finished, calibrated, and I think it's great results.
Great job! I think the .3mm results look effectively perfect and probably about as good as one can ever expect to get.
For the .1mm prints, software compensation or one of the slip-joint solutions might be able to finally rid the slight banding that is still there, but if not, going to a .5mm thread pitch will squeeze the bands 37% closer together, which IMHO looks even less noticeable than banding at .8mm. The flexibility and tighter thread tolerances would probably help too. I don't think anybody has done a side-by-side comparison of an M3 vs an M5 with the same printer--so I'm curious--but my gut reaction is still that the finer the thread, the better the print will likely be.