1 Topic by Cyber-Monkey (edited by Cyber-Monkey 2014-02-03 07:44:39)

  • Cyber-Monkey
  • Newbie
  • Offline
  • From: Melbourne, Australia
  • Registered: 2013-12-14
  • Posts: 9

Topic: Connection Issues.

Hello everyone,

I've updated to the latest Repetier, however now i cannot connect to my printer.
I have re-installed the drivers but still cannot connect.
Any help?

Thank you.

2 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: Connection Issues.

Is  the com port set correctly?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

3 Reply by Cyber-Monkey

  • Cyber-Monkey
  • Newbie
  • Offline
  • From: Melbourne, Australia
  • Registered: 2013-12-14
  • Posts: 9

Re: Connection Issues.

Yes, when I run the older version that I downloaded from solidoodle i can connect, however when I downloaded a new version it cannot.

4 Reply by COASTER19

  • COASTER19
  • COASTER19
  • Member
  • Offline
  • From: Kansas
  • Registered: 2013-03-08
  • Posts: 235

Re: Connection Issues.

Possibly try running the program as root?  It would rule out any permissions issues.

5 Reply by rjp350z

  • rjp350z
  • rjp350z
  • Member
  • Offline
  • From: Bloomfield, NJ
  • Registered: 2013-01-11
  • Posts: 249

Re: Connection Issues.

Try Changing RESET ON CONNECT to "disabled under printer settings

6 Reply by G-unit

  • G-unit
  • Member
  • Offline
  • Registered: 2013-08-02
  • Posts: 52

Re: Connection Issues.

rjp350z wrote:

Try Changing RESET ON CONNECT to "disabled under printer settings

This should fix it..

7 Reply by Cyber-Monkey

  • Cyber-Monkey
  • Newbie
  • Offline
  • From: Melbourne, Australia
  • Registered: 2013-12-14
  • Posts: 9

Re: Connection Issues.

Hey, sorry it took me a while but that had fixed the issue.
Thank you