1 Topic by dubbsd (edited by dubbsd 2014-02-03 22:11:09)

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: need help with azteeg 8825 stepper driver

I have an Azteeg x3 board and Azteeg 8825 stepper drivers. All the documentation is unclear. How do I orientate the stepper drivers.

Thanks in advance.

Ultimaker S3.

2 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: need help with azteeg 8825 stepper driver

can anyone help me on this

Ultimaker S3.

3 Reply by IanJohnson

  • IanJohnson
  • Moderator
  • Offline
  • Registered: 2012-08-07
  • Posts: 2,815

Re: need help with azteeg 8825 stepper driver

The pot (and the DIR and GND pins) go at the edge of the board.

4 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: need help with azteeg 8825 stepper driver

Thanks Ian
I did  not want to take a chance and burn something out.

Ultimaker S3.