Topic: extruder
hello
I work with a solidoodle2
the extruder don't heat anymore
somebody know why ?
everything works,
regard
- IronMan
- PRINTiT
- Offline
Re: extruder
Read Danny's sticky...
http://www.soliforum.com/topic/636/hot- … to-repair/
Good Luck!
SD2 - Stock - Enclosure - Heated Bed - Glass Plate - Auto Fire Extinguisher
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!
Re: extruder
The first thing to check is the simplest: Has the connector fallen off the motherboard? It gets more complex from there :-).
- SnakeEyes
- Member
- Offline
Re: extruder
Is it actually not hot or is it hot but the software thinks its not?
Overkill is underrated!!!
Re: extruder
It Is not hot
- wardjr
- Moderator
- Offline
Re: extruder
Have you checked the resistance of the heater cartridge? I just pulled out my old SD hot end and it measured 7.2 Ohms
I don't know if that's right but it worked when I took it off. Also if you apply 12V across it should heat up. Make sure you unplug from the board first. I used to use a car battery to heat it up when I had clogs.
Maybe it is time to upgrade to an E3D.
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
Re: extruder
A quick way to test if the mosfet is bad is swap the bed and extruder plugs on the bottom of the main board then turn on the bed to send power to the extruder, !!! be careful !!! and only do this if you understand what it is doing...as there will be no temp control to prevent the hotend from destroying itself... you shouldn't have to leave it switched on for more than 10-20 seconds to see if it is getting hot or not.
Re: extruder
Thank you ronsii
Îles it work, so what it is the motherboard?
Re: extruder
I Think it Is the connector between the motherboard and the extruder, i change with the bed connector, and That work
Do you Think That i can do something ?