You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Help/Repair/Maintenance → Calibration Help
Hello,
Based on the picture attached, what can I do to get the filament to form together, because it looks like there are holes/gaps in between each line of filament. Thanks
(also how do you add the pictures directly into the post)
have you done any calibration at all?
first you want to calibrate your extuder steps per min. from the shop they over extrude by about 20%
http://solidoodletips.wordpress.com/201 … libration/
then you want to measure your filament at a few spots then average it out and then find your extrusion multiplier
http://solidoodletips.wordpress.com/201 … flow-rate/
my internet is screwy and isnt loading your picture but gaps between lines if everything else is calibrated usually means you need to bring your nozzle closer to the bed
lots of good stuff on that wordpress helped me alot when i got started
Hi, thanks for replying, I did already calibrate the extruder steps per min, but havent done the second one, ill try doing that now.
whats your new steps per minute number ?
110, before i think it was at 135 or something
good that sounds about right. did that extrusion multiplier get you all sorted out? dont forget you might need to bring your bed up a tiny bit.
Hey, Thank you so much, its perfect now, the multiplier before i calibrated it was .6, and after calibration it is .79, and another thing that affected it was that i had 8 minimum perimeters for some reason. Thanks again.
SoliForum - 3D Printing Community → Help/Repair/Maintenance → Calibration Help
Powered by PunBB, supported by Informer Technologies, Inc.
