1 Topic by teddygrahams

  • teddygrahams
  • Member
  • Offline
  • Registered: 2013-06-19
  • Posts: 15

Topic: Problems with slicing

I am attempting to print a model with no base, top, or infill. So basically  the outer shell. It has worked on all my other models I have been printing except this one. Something weird happens and I can't figure it out.
http://gyazo.com/3fb6651a8695249d446f57e0d5c10deb   --- That shows the very odd slicing its applying to the top. Also to let you know when it starts printing the y axis coordinate turns red even though the print is on the plate.

Thanks so much for helping.

P.s. This is on a solidoodle 2

Post's attachments

elow5.stl 37.19 kb, 5 downloads since 2014-01-06 

You don't have the permssions to download the attachments of this post.

2 Reply by teddygrahams

  • teddygrahams
  • Member
  • Offline
  • Registered: 2013-06-19
  • Posts: 15

Re: Problems with slicing

In reality its only for parts were the top is slanted will it do this. But the problem is I need the slant