1 Topic by 3d4me

  • 3d4me
  • Newbie
  • Offline
  • Registered: 2014-01-01
  • Posts: 3

Topic: New SD2 not responding to Run Command

Hello community,

I am brand new to 3d printing.  I successfully printed the spool mount the first night I got this.  Since then, I have not been able to print another item.

I have tested the x axis, y axis, z axis and have also been able to extrude filament from the hot nozzle all manually from the print panel.  I have also been able to use slicer to create the g-code.

When I press the Run command, nothing happens.  The SD2 does not respond at all.  When I press Kill job, the message on the bottom of the screen is "9 commands waiting"  (27 commands waiting after three tries).

Any suggestions?  Thanks!

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: New SD2 not responding to Run Command

What are the details of your setup? computer os, repetier? slicer? file you are trying to print?, stl

3 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: New SD2 not responding to Run Command

one other thing make sure the comm port has not changed

4 Reply by 3d4me

  • 3d4me
  • Newbie
  • Offline
  • Registered: 2014-01-01
  • Posts: 3

Re: New SD2 not responding to Run Command

Hi Ronsii,  I have a MacOS, Repetier Host-Mac Version 0.56, Comm port is still usbmodem12341.   I was just trying to run the standard SpoolMount.stl again.

Thanks

5 Reply by 3d4me

  • 3d4me
  • Newbie
  • Offline
  • Registered: 2014-01-01
  • Posts: 3

Re: New SD2 not responding to Run Command

Any ideas that could help me please?

Thanks!