You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Discussion → Samples for Future Builder
Who could I contact to get some samples printed out for me? It would be my pleasure to pay someone up to $10 to print out some samples so that I can feel first hand what kind of product these machines can produce.
A nice 2"x2" spoked gear would be nice I think. Maybe a range of 100 microns, 200 microns, and 300 microns?
I'm sure there are a few people about who could do that, where are you located?
I'm sure there are a few people about who could do that, where are you located?
I'm in Washington State.
and that would be in the USA?
I'm being cheeky, but it always amazes me that people just assume others are in the same country and know where a place is.
and that would be in the USA?
I'm being cheeky, but it always amazes me that people just assume others are in the same country and know where a place is.
I knew it! I was going to state that in my first post because it seems theres people from everywhere on here but I was running short on time. I know what you mean though!
Also being cheeky (a wise ass), most people here work in metric, so we have to assume you meant about 50mm.
I am from Pennsyltucky USA and even I know that, sheesh.
If you want to try to design exactly what you are looking for see this site.
woodgears.ca/gear_cutting/template.htm
Odd though that it is a Canadian site and supports Spanish but not French.
SoliForum - 3D Printing Community → Solidoodle Discussion → Samples for Future Builder
Powered by PunBB, supported by Informer Technologies, Inc.
