<![CDATA[SoliForum - 3D Printing Community — Samples for Future Builder]]> https://www.soliforum.com/topic/3715/samples-for-future-builder/ Sun, 01 Sep 2013 18:44:53 +0000 PunBB <![CDATA[Re: Samples for Future Builder]]> https://www.soliforum.com/post/34881/#p34881 Also being cheeky (a wise ass), most people here work in metric, so we have to assume you meant about 50mm.
I am from Pennsyltucky USA and even I know that, sheesh.

If you want to try to design exactly what you are looking for see this site.
woodgears.ca/gear_cutting/template.htm
Odd though that it is a Canadian site and supports Spanish but not French.

]]> Sun, 01 Sep 2013 18:44:53 +0000 https://www.soliforum.com/post/34881/#p34881 <![CDATA[Re: Samples for Future Builder]]> https://www.soliforum.com/post/34631/#p34631 Gomisan wrote:

and that would be in the USA?

I'm being cheeky, but it always amazes me that people just assume others are in the same country and know where a place is.

I knew it! I was going to state that in my first post because it seems theres people from everywhere on here but I was running short on time. I know what you mean though!

]]> Thu, 29 Aug 2013 23:44:57 +0000 https://www.soliforum.com/post/34631/#p34631 <![CDATA[Re: Samples for Future Builder]]> https://www.soliforum.com/post/34629/#p34629 and that would be in the USA?

I'm being cheeky, but it always amazes me that people just assume others are in the same country and know where a place is.

]]> Thu, 29 Aug 2013 23:35:37 +0000 https://www.soliforum.com/post/34629/#p34629 <![CDATA[Re: Samples for Future Builder]]> https://www.soliforum.com/post/34541/#p34541 Gomisan wrote:

I'm sure there are a few people about who could do that, where are you located?

I'm in Washington State.

]]> Thu, 29 Aug 2013 11:53:04 +0000 https://www.soliforum.com/post/34541/#p34541 <![CDATA[Re: Samples for Future Builder]]> https://www.soliforum.com/post/34535/#p34535 I'm sure there are a few people about who could do that, where are you located?

]]> Thu, 29 Aug 2013 10:36:04 +0000 https://www.soliforum.com/post/34535/#p34535 <![CDATA[Samples for Future Builder]]> https://www.soliforum.com/post/34533/#p34533 Who could I contact to get some samples printed out for me? It would be my pleasure to pay someone up to $10 to print out some samples so that I can feel first hand what kind of product these machines can produce.

A nice 2"x2" spoked gear would be nice I think. Maybe a range of 100 microns, 200 microns,  and 300 microns?

]]> Thu, 29 Aug 2013 08:25:18 +0000 https://www.soliforum.com/post/34533/#p34533