1 Topic by michael.t.albers

  • michael.t.albers
  • Member
  • Offline
  • Registered: 2013-06-07
  • Posts: 164

Topic: A little help with Repetier Host and Slic3r

Looking for a little help.  Really new to the whole 3d printer process, so not very tech savvy.  I have gotten prints printed using Repetier Host and Slic3r set on the .3mm setting, but everytime I try to slice smaller (.1mm or .2mm settings), I get an error code that says "Argument\x(35\x(30)... isn't numeric in multiplication (*) at C:/prigr...line38"
Does anyone know what is causing this?   thanks for any and all help:)

2 Reply by rjp350z

  • rjp350z
  • rjp350z
  • Member
  • Offline
  • From: Bloomfield, NJ
  • Registered: 2013-01-11
  • Posts: 249

Re: A little help with Repetier Host and Slic3r

I've seen this before if you have one of the settings set to a non-numeric value. Check to make sure the .1 and .2 mm configs have only nemeric values in them. (ie a % sign where is does not belong)

Compare the .3 to the other two find the differences is real y the only way to track it down.

3 Reply by michael.t.albers

  • michael.t.albers
  • Member
  • Offline
  • Registered: 2013-06-07
  • Posts: 164

Re: A little help with Repetier Host and Slic3r

Thanks for the input, I will check those settings!