<![CDATA[SoliForum - 3D Printing Community — A little help with Repetier Host and Slic3r]]> https://www.soliforum.com/topic/3375/a-little-help-with-repetier-host-and-slic3r/ Wed, 31 Jul 2013 20:34:55 +0000 PunBB <![CDATA[Re: A little help with Repetier Host and Slic3r]]> https://www.soliforum.com/post/31559/#p31559 Thanks for the input, I will check those settings!

]]> Wed, 31 Jul 2013 20:34:55 +0000 https://www.soliforum.com/post/31559/#p31559 <![CDATA[Re: A little help with Repetier Host and Slic3r]]> https://www.soliforum.com/post/31532/#p31532 I've seen this before if you have one of the settings set to a non-numeric value. Check to make sure the .1 and .2 mm configs have only nemeric values in them. (ie a % sign where is does not belong)

Compare the .3 to the other two find the differences is real y the only way to track it down.

]]> Wed, 31 Jul 2013 16:52:20 +0000 https://www.soliforum.com/post/31532/#p31532 <![CDATA[A little help with Repetier Host and Slic3r]]> https://www.soliforum.com/post/31477/#p31477 Looking for a little help.  Really new to the whole 3d printer process, so not very tech savvy.  I have gotten prints printed using Repetier Host and Slic3r set on the .3mm setting, but everytime I try to slice smaller (.1mm or .2mm settings), I get an error code that says "Argument\x(35\x(30)... isn't numeric in multiplication (*) at C:/prigr...line38"
Does anyone know what is causing this?   thanks for any and all help:)

]]> Wed, 31 Jul 2013 04:32:44 +0000 https://www.soliforum.com/post/31477/#p31477