1 Topic by MolecularConcept (edited by MolecularConcept 2013-07-28 18:38:34)

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Topic: repetier host G code editor

if i make a change in the G code editor  like the nozell diameter from 4 to 3.5  its going to use that edited value correct? 

i ask cause i have r hose .85 and slicer .9.9 and the default diameter in was 4 so i just edited it right in the editor untill i can find the option to change it in the config(its not there for some reason or i cant find it)

EDIT: oh my my shits all out of wack since the upgrade! going backwards! lol  ran configuration wizzard and set the nozzle diameter to .35 it rounds it up to 4 . and its start G code is all screwy  its just all around messed up going back to .82

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: repetier host G code editor

You have to edit the slicer config since it is the program doing all the figuring, any mention of nozzle size in gcode is just for reference.

3 Reply by MolecularConcept

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Re: repetier host G code editor

thats what i thought. thanks