1 Topic by MolecularConcept

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Topic: Custom Start G Code?

so i finaly did my first prints!!! and a few things i notice right off the bat, i need to print an anchor. when it gote to print the skirt it only get half of it.   and my cubes arent cubes  my X axis is 10mm my my Y  is 9.72 and Z is 9.72 

also  i printed 3 thumb screws that look okay.

and in slicer if you click configure and make changes is there no way to save them?

how the eff do i print and anchor ?

if this post is in the wrong place please move it to where it should go.

2 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Custom Start G Code?

Anchor here:

http://www.soliforum.com/topic/231/impr … end-gcode/

lawsy's Website

3 Reply by MolecularConcept

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Re: Custom Start G Code?

THANKS!

4 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Custom Start G Code?

Also in Slic3r, there is a little disk icon for save. Click it and a box will appear with a name. Change the name to save a new profile or keep the same name to update the current profile.

lawsy's Website

5 Reply by MolecularConcept

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Re: Custom Start G Code?

now im having a problem editing the G code.  im using the repetier host slicer app and when your in the configure part  where you change the infill and perimeters, theres no option to SAVE the stuff you change?

6 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Custom Start G Code?

http://forums.reprap.org/file.php?263,file=13144,filename=Slic3rSpeedSettings.png

Not my pic so ignore the blue box.

Save icon can be seen at the top left, immediately to the right of '- Default -'.

lawsy's Website

7 Reply by MolecularConcept

  • MolecularConcept
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2013-06-03
  • Posts: 392

Re: Custom Start G Code?

ooh ok thanks I was looking for a box at the bottom labeled SAVE for dummies like me....