1 Topic by mr_tim34

  • mr_tim34
  • Member
  • Offline
  • Registered: 2013-02-17
  • Posts: 111

Topic: New Slic3R problem

All of a sudden I can't slice anything with Slic3r. I get the following error:

Thread 3 terminated abnormally: Argument "" isn't numeric in numeric gt (>) at c:/Slic3r/lib/std/Slic3r/print.pm line 640.

I get this error when I try to slice things I've already sliced. I apparently changed something somewhere. Any ideas?

Thanks,

TiM

2 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: New Slic3R problem

I just got an error like that. The only things that I had changed were some hard coded speeds. I set these to percentages and that is when I was getting the error. I switched them back and there error went away.

I don't know if you are having the same issue but that is what worked for me.

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website

3 Reply by mr_tim34

  • mr_tim34
  • Member
  • Offline
  • Registered: 2013-02-17
  • Posts: 111

Re: New Slic3R problem

Thanks for the input 2n2r5. I thought about what I had changed. The part I was trying to print was taking up the whole bed so I turned off the brim by deleting the 2 that was in the box instead of putting a 0 in there... Know I know...

TiM