1 Topic by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Topic: Cable Chain (Level 1 - Novice Consumer)

Tidy up your wiring once and for all. My cables were constantly getting into the wrong places, and sometimes even ruining prints.

This cable chain safely guides the wires from the extruder carriage to the back of the case. All parts print without support and snap together without nuts, bolts or glue.

Further instructions available on Thingiverse.

http://www.thingiverse.com/thing:104817

http://thingiverse-production.s3.amazonaws.com/renders/9d/dd/95/89/68/WP_20130617_001_preview_featured.jpg

lawsy's Website

2 Reply by Staffordknot

  • Staffordknot
  • Member
  • Offline
  • Registered: 2013-04-28
  • Posts: 199

Re: Cable Chain (Level 1 - Novice Consumer)

Lol... Love it!

3 Reply by nlancaster (edited by nlancaster 2013-06-17 16:21:12)

  • nlancaster
  • Member
  • Offline
  • Registered: 2013-03-20
  • Posts: 266

Re: Cable Chain (Level 1 - Novice Consumer)

How about some video of it in action lawsy?

I have been wanting to do that on my SD3 and have yet to find a good way to route the cable chain.

4 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Cable Chain (Level 1 - Novice Consumer)

nlancaster wrote:

How about some video of it in action lawsy?

I have been wanting to do that on my SD3 and have yet to find a good way to route the cable chain.

Watch this pace...

lawsy's Website