Topic: Electrical Shematic for the Sanguino Card
Someone can give me the location where we plug the heating resistor and the thermistor for the heating bed?
Re: Electrical Shematic for the Sanguino Card
- 2n2r5
- Member
- Offline
Re: Electrical Shematic for the Sanguino Card
elmoret wrote:
http://lmgtfy.com/?q=sanguinololu
First link.
That is an awesome page.
SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Re: Electrical Shematic for the Sanguino Card
Wow. Nice response to someone that was helping you. If you look at the wiring diagram on the reprap page you can see where everything plugs in, bot thermistors, heat bed, axis motors, etc. very useful! http://reprap.org/wiki/File:Sanguinololu12.svg
SD2
E3D V6
MK5 V6
E3D V6
MK5 V6
Re: Electrical Shematic for the Sanguino Card
2n2r5 wrote:
elmoret wrote:http://lmgtfy.com/?q=sanguinololu
First link.
That is an awesome page.
+1
Will be hard not to overuse it.