1 Topic by cordvision

  • cordvision
  • Member
  • Offline
  • Registered: 2013-05-14
  • Posts: 34

Topic: PID tuning (Mac)

I have a little problem. I did run the PID tuning procedure. Now I'm supposed to update the eeprom settings. On repetier for Macs, I have the option for printer, EEPROM settings, but the window that opens up to configure is empty. I don't see any values that I could change or update, it's just a blank page. What am I missing?

2 Reply by cordvision (edited by cordvision 2013-06-07 03:01:30)

  • cordvision
  • Member
  • Offline
  • Registered: 2013-05-14
  • Posts: 34

Re: PID tuning (Mac)

Sorry, jumped the gun on my last question. Found the answer here:

http://www.soliforum.com/topic/1388/tem … -problems/

MODS: Feel free to delete this topic...

3 Reply by cordvision

  • cordvision
  • Member
  • Offline
  • Registered: 2013-05-14
  • Posts: 34

Re: PID tuning (Mac)

Would be nice if this info could be added to the solidoodle wiki... The steps for PID tuning don't work if you are on a Mac. On the mac the eeprom window is blank (confirmed by others).