1 Topic by bigEcooperpants

  • bigEcooperpants
  • Newbie
  • Offline
  • Registered: 2013-01-05
  • Posts: 1

Topic: Solidoodle 3 problems in repeiter

My solidoodle 3 was working fine bu then i started getting these error messages. Im totally new to solidoodle and am confused by messages. Please help.

Post's attachments

Capture.PNG
Capture.PNG 260.25 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Solidoodle 3 problems in repeiter

Loose wire for extruder thermistor.

Dodgy connector strikes again!

lawsy's Website

3 Reply by Skyblue

  • Skyblue
  • Member
  • Offline
  • From: Keller, Texas
  • Registered: 2013-01-04
  • Posts: 201

Re: Solidoodle 3 problems in repeiter

bigEcooperpants wrote:

My solidoodle 3 was working fine bu then i started getting these error messages. Im totally new to solidoodle and am confused by messages. Please help.

Had that happen to me a few times, before I realized I was running too hot!  Machine would error out and direct me to restart also, would not work for some reason though.  I now leave the heat alone, unless just 1 or 2 degrees warmer.  Go to 209 or so and the machine will error out to protect the peek etc.....