1 Topic by digiprint

  • digiprint
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 76

Topic: Calibration STL

Hi everyone!

I want to adjust my flow-rate.
In the most posts and in the wiki there is a box shown.
Is there a STL for it?

A sticky with calibration STL would be great. Everyone has another idea how to do this smile

2 Reply by CrazyBear

  • CrazyBear
  • Member
  • Offline
  • From: Orange County, CA
  • Registered: 2013-02-18
  • Posts: 82

Re: Calibration STL

Here you go...

https://github.com/alexrj/Slic3r/wiki/Calibration

3 Reply by digiprint

  • digiprint
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 76

Re: Calibration STL

Today nothing works!
What is wrong with my slicer-settings? Tried to slice the 40x10 stl but nothing comes out.
I have the factory settings from Solidoodle.

4 Reply by digiprint

  • digiprint
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 76

Re: Calibration STL

Downloaded this from thingiverse

Post's attachments

A_Half_mm_single_wall_calibration_piece.stl 86.62 kb, 24 downloads since 2013-03-19 

Test_Tube.STL 20.98 kb, 13 downloads since 2013-03-19 

You don't have the permssions to download the attachments of this post.

5 Reply by FatalDischarge

  • FatalDischarge
  • Member
  • Offline
  • From: Arvada, CO
  • Registered: 2012-12-30
  • Posts: 129

Re: Calibration STL

digiprint wrote:

Today nothing works!
What is wrong with my slicer-settings? Tried to slice the 40x10 stl but nothing comes out.
I have the factory settings from Solidoodle.

There seems to be something wrong with that download. Try the .5 test here: http://www.thingiverse.com/thing:5573
In Slic3r, set infill to 0, set perimeters to 1, in the "advanced" print setting set perimeters to .5, print and check with calipers. This is what I do and it seems to work. I did it just now and saw that I had to change the multiplier.