1 Topic by jjcuff1 (edited by jjcuff1 2013-03-13 19:28:52)

  • jjcuff1
  • Member
  • Offline
  • Registered: 2012-10-18
  • Posts: 253

Topic: RH losing values in FIRMWARE

Well battling y axis problems thought I had it licked last night. Had my first good print in over a week, alignment feels solid.
switched to glass bed (OMG) should have done that from start

All my default values in RH load up as zero!
I relaoded everythign and it works but just heaters turn on/off

I can send M92 and M201 codes then manually drive the motors but they just barely budge..

SD2 owner- Surestepr, filament holder,QUBD servo and heaters, glass bed
Print for fun and for parts for my sports cars
current car is 88 IROC

2 Reply by jjcuff1

  • jjcuff1
  • Member
  • Offline
  • Registered: 2012-10-18
  • Posts: 253

Re: RH losing values in FIRMWARE

Well I finally got it to respond again.

I loaded up into Pronterface (has same problem) but it accepted the M500 line
So I manually entered M92,M201,M203,M204,M205,M301 from marlin.pde file into Pronterface and did a M500
then M501 and they were there. Now The motors moved but apparently Y had locked up again bound so hence why my print stopped probably locked up really bad

I went back into RH and it recognized the eprom data and loaded the values. I was up and running again.

SD2 owner- Surestepr, filament holder,QUBD servo and heaters, glass bed
Print for fun and for parts for my sports cars
current car is 88 IROC

3 Reply by cmetzel

  • cmetzel
  • Member
  • Offline
  • From: Solidoodle2 #0091
  • Registered: 2012-08-22
  • Posts: 1,429

Re: RH losing values in FIRMWARE

Not that I would have been any help on this but I thought SAGA was a brand name or something so I didn't look at the thread originally.   Good that you're up and running again.

4 Reply by jjcuff1

  • jjcuff1
  • Member
  • Offline
  • Registered: 2012-10-18
  • Posts: 253

Re: RH losing values in FIRMWARE

LOL changed this should help out the next guy

SD2 owner- Surestepr, filament holder,QUBD servo and heaters, glass bed
Print for fun and for parts for my sports cars
current car is 88 IROC