1 Topic by MohG

  • MohG
  • Member
  • Offline
  • Registered: 2017-03-28
  • Posts: 16

Topic: SABIC MG47F ?

I would like to know whether SABIC MG47F ABS works for extrusion and 3D printing as MG94 ?

comparison here :

https://www.sabic.com/en/products/compa … 0c2926daac

min Qt to buy is 25kg that's why i'm asking before buying.

2 Reply by MohG

  • MohG
  • Member
  • Offline
  • Registered: 2017-03-28
  • Posts: 16

Re: SABIC MG47F ?

Forum search "MG47" = no cat in the horizon

google search http://www.soliforum.com/topic/14945/abs-mg47-cycolac/

3 Reply by genesat1

  • genesat1
  • Member
  • Offline
  • Registered: 2015-04-26
  • Posts: 184

Re: SABIC MG47F ?

Melt flow is lower so it would extrude slower, but it should still be usable for filament extrusion.  I can’t guarantee it since I haven’t used this specific type, but in general ABS is the easiest to extrude.

4 Reply by MohG (edited by MohG 2024-07-01 21:16:02)

  • MohG
  • Member
  • Offline
  • Registered: 2017-03-28
  • Posts: 16

Re: SABIC MG47F ?

genesat1 wrote:

Melt flow is lower so it would extrude slower, but it should still be usable for filament extrusion.  I can’t guarantee it since I haven’t used this specific type, but in general ABS is the easiest to extrude.

The filament is indeed slow to extrude and difficult to print with, I found that adding colorant increases the melt flow rate, and improves the print quality, in case anyone wants to try it, when colored give very good quality filament, photos and details Here