1 Topic by jbh2018uk

  • jbh2018uk
  • Newbie
  • Offline
  • Registered: 2018-08-08
  • Posts: 2

Topic: Help - XYZ Da Vinci 1.0 JNR

So had this printed 2 days now and each time the plastic tube comes out of left extruder and doesnt push into the printer head. Any ideas why ?

Thanks

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Help - XYZ Da Vinci 1.0 JNR

elcheapo bowden tube connectors . buy some good connectors and some good tubing

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by jbh2018uk

  • jbh2018uk
  • Newbie
  • Offline
  • Registered: 2018-08-08
  • Posts: 2

Re: Help - XYZ Da Vinci 1.0 JNR

Any recommendations as to where to get them and which

thanks

4 Reply by Tin Falcon (edited by Tin Falcon 2018-08-09 08:14:14)

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Help - XYZ Da Vinci 1.0 JNR

https://www.printedsolid.com/collection … n-coupling
https://www.printedsolid.com/collection … 7610453836

the top two are premium parts



https://www.printedsolid.com/products/ptfe-tubing
https://www.folgertech.com/products/2me … ap-rostock


https://www.ebay.com/itm/Push-Fit-Pneum … itleDesc=0

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

5 Reply by sdburton

  • sdburton
  • Newbie
  • Offline
  • Registered: 2018-08-28
  • Posts: 8

Re: Help - XYZ Da Vinci 1.0 JNR

I've been using my Jr 1.0 with no problems with the feed tube.  There is only 1 extruder and it's on the right side of the printer if you are looking at it. The feed tube connects to the filament feed drive on the left and you need to insert the tube about 3/4 of inch into the tube fitting.  It's easier if you ease the left side open to help guide the tube in. Push it in, until it seats. This is the same type of tube fitting that's on the extruder, with the little black spring release ring on top.