SoliForum - 3D Printing Community — Help - XYZ Da Vinci 1.0 JNR

Re: Help - XYZ Da Vinci 1.0 JNR

null@example.com (sdburton) — Tue, 28 Aug 2018 17:19:54 +0000

I've been using my Jr 1.0 with no problems with the feed tube. There is only 1 extruder and it's on the right side of the printer if you are looking at it. The feed tube connects to the filament feed drive on the left and you need to insert the tube about 3/4 of inch into the tube fitting. It's easier if you ease the left side open to help guide the tube in. Push it in, until it seats. This is the same type of tube fitting that's on the extruder, with the little black spring release ring on top.

Re: Help - XYZ Da Vinci 1.0 JNR

null@example.com (Tin Falcon) — Wed, 08 Aug 2018 23:18:01 +0000

https://www.printedsolid.com/collection … n-coupling
https://www.printedsolid.com/collection … 7610453836

the top two are premium parts

https://www.printedsolid.com/products/ptfe-tubing
https://www.folgertech.com/products/2me … ap-rostock

https://www.ebay.com/itm/Push-Fit-Pneum … itleDesc=0

Re: Help - XYZ Da Vinci 1.0 JNR

null@example.com (jbh2018uk) — Wed, 08 Aug 2018 22:49:59 +0000

Any recommendations as to where to get them and which

thanks

Re: Help - XYZ Da Vinci 1.0 JNR

null@example.com (Tin Falcon) — Wed, 08 Aug 2018 22:04:40 +0000

elcheapo bowden tube connectors . buy some good connectors and some good tubing

Help - XYZ Da Vinci 1.0 JNR

null@example.com (jbh2018uk) — Wed, 08 Aug 2018 21:45:11 +0000

So had this printed 2 days now and each time the plastic tube comes out of left extruder and doesnt push into the printer head. Any ideas why ?

Thanks