1 Topic by lotusteve

  • lotusteve
  • Member
  • Offline
  • Registered: 2018-01-13
  • Posts: 26

Topic: latest junior firmware information

iam using a junior on the latest firmware, in xyz slicer i have seen settings to adjust nozzle temps and a few other adjustments, if i mess with the adjustments will my junior print with the new adjustments ?. or does the junior ignore them and do its own thing.

2 Reply by Magic Matt

  • Magic Matt
  • Member
  • Offline
  • Registered: 2017-12-30
  • Posts: 35

Re: latest junior firmware information

The nozzle temp adjust is relative to the temperature on the spool tag. You can go up or down by up to 10C. It is specifically for the Junior and Mini.

I'm a total newcomer to 3D printing, based in the UK, and have a DaVinci Junior 1.0
My background is programming, web design, and vinyl cutting!

3 Reply by lotusteve

  • lotusteve
  • Member
  • Offline
  • Registered: 2018-01-13
  • Posts: 26

Re: latest junior firmware information

Magic Matt wrote:

The nozzle temp adjust is relative to the temperature on the spool tag. You can go up or down by up to 10C. It is specifically for the Junior and Mini.

ok iam using white at the moment and i have upped the temp by 10deg in the xyz slicer software, lowered from 0.3 to 0.2 and set the speed to slow. and it prints the white just about perfect now, so i think the small adjustments make a difference to my prints.