1 Topic by Daveyboy33i

  • Daveyboy33i
  • Newbie
  • Offline
  • Registered: 2017-08-01
  • Posts: 1

Topic: I am new

hi there, i am new to the forum, and new to 3D printing

My wife bought me a XYZ Davinci Jr 1.0 for my birthday, now having done a quick bit of looking around, i have heard its a good entry level printer, and that you can only use their own filament as it is chipped.

But as a newbie, who has literally only printed out the test object that comes on the SD card with the machine i am after a little bit of knowledge from people that use these machines (you lot lol)

so any advice for a complete beginner would be grateful, and i hope i enjoy it as much as i believe i am going to enjoy the whole 3D printing world

Thank you in advance

Dave

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: I am new

Welcome Dave!

you may want to do a bit of digging around in the XYZ DaVinci section of the forums, there are plenty of folks there that can help you out with your printer.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1