1 Topic by jinxycob (edited by jinxycob 2017-04-16 21:02:43)

  • jinxycob
  • Member
  • Offline
  • Registered: 2017-03-18
  • Posts: 21

Topic: auger 12mm!

Its finally arrived, brits postal service tortured me!.

while assembling and sorting the collar i measured  the auger protruding 12mm outside the barrel with the collar right up against the screw. 

http://www.robotrebels.org/gallery/16_16_04_17_4_00_46.jpeg

can I get away with that ?

could I just stack some washer behind the flange and bring  the barrel forward  that way?

2 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: auger 12mm!

12mm is fine. If it's a concern you could put a set of the 1/4" washers between the flange and the lasercut part.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend

3 Reply by jinxycob

  • jinxycob
  • Member
  • Offline
  • Registered: 2017-03-18
  • Posts: 21

Re: auger 12mm!

If it's a concern you could put a set of the 1/4"

am not concerned if you not concerned tongue


its all sounding good. start the purge today.