<![CDATA[SoliForum - 3D Printing Community — auger 12mm!]]> https://www.soliforum.com/topic/16348/auger-12mm/ Wed, 19 Apr 2017 06:51:47 +0000 PunBB <![CDATA[Re: auger 12mm!]]> https://www.soliforum.com/post/134705/#p134705

If it's a concern you could put a set of the 1/4"

am not concerned if you not concerned tongue


its all sounding good. start the purge today.

]]> Wed, 19 Apr 2017 06:51:47 +0000 https://www.soliforum.com/post/134705/#p134705 <![CDATA[Re: auger 12mm!]]> https://www.soliforum.com/post/134633/#p134633 12mm is fine. If it's a concern you could put a set of the 1/4" washers between the flange and the lasercut part.

]]> Sun, 16 Apr 2017 21:57:44 +0000 https://www.soliforum.com/post/134633/#p134633 <![CDATA[auger 12mm!]]> https://www.soliforum.com/post/134632/#p134632 Its finally arrived, brits postal service tortured me!.

while assembling and sorting the collar i measured  the auger protruding 12mm outside the barrel with the collar right up against the screw. 

http://www.robotrebels.org/gallery/16_16_04_17_4_00_46.jpeg

can I get away with that ?

could I just stack some washer behind the flange and bring  the barrel forward  that way?

]]> Sun, 16 Apr 2017 20:07:35 +0000 https://www.soliforum.com/post/134632/#p134632