1 Topic by crazyewok

  • crazyewok
  • Member
  • Offline
  • Registered: 2015-10-27
  • Posts: 11

Topic: Cleaned Extruder head and LCD screen broke?

Had a problem with a clogged extruder.

So I removed it and soaked it in some acetone.

Fitted it back together and the little screen at the front has stopped working.

Is there a wire I could have accidently pulled?

2 Reply by ap742

  • ap742
  • Newbie
  • Offline
  • Registered: 2016-06-07
  • Posts: 8

Re: Cleaned Extruder head and LCD screen broke?

did you figure out ?
I might have similar issue .
except I think I shorted board on top of the extruder

3 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Cleaned Extruder head and LCD screen broke?

You both probably shorted the 12 volts at the heater to ground. Read the sticky at the top of the XYZ section. There is a link near the end that explains what to do to fix the problem.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.