<![CDATA[SoliForum - 3D Printing Community — Cleaned Extruder head and LCD screen broke?]]> https://www.soliforum.com/topic/13808/cleaned-extruder-head-and-lcd-screen-broke/ Tue, 07 Jun 2016 18:18:36 +0000 PunBB <![CDATA[Re: Cleaned Extruder head and LCD screen broke?]]> https://www.soliforum.com/post/123852/#p123852 You both probably shorted the 12 volts at the heater to ground. Read the sticky at the top of the XYZ section. There is a link near the end that explains what to do to fix the problem.

]]> Tue, 07 Jun 2016 18:18:36 +0000 https://www.soliforum.com/post/123852/#p123852 <![CDATA[Re: Cleaned Extruder head and LCD screen broke?]]> https://www.soliforum.com/post/123838/#p123838 did you figure out ?
I might have similar issue .
except I think I shorted board on top of the extruder

]]> Tue, 07 Jun 2016 14:24:13 +0000 https://www.soliforum.com/post/123838/#p123838 <![CDATA[Cleaned Extruder head and LCD screen broke?]]> https://www.soliforum.com/post/117119/#p117119 Had a problem with a clogged extruder.

So I removed it and soaked it in some acetone.

Fitted it back together and the little screen at the front has stopped working.

Is there a wire I could have accidently pulled?

]]> Sun, 21 Feb 2016 17:29:46 +0000 https://www.soliforum.com/post/117119/#p117119