1 Topic by parentemv

  • parentemv
  • Member
  • Offline
  • Registered: 2014-12-05
  • Posts: 100

Topic: Filament hack

My 1.0a has 2.1.0 firmware on it. Haven't found any info regarding filament hack for this version.

Any suggestions.

Thanks

2 Reply by scobo (edited by scobo 2016-06-13 16:13:01)

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Re: Filament hack

Repetier, best filament hack there is !

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs

3 Reply by db69510

  • db69510
  • Newbie
  • Offline
  • Registered: 2016-06-09
  • Posts: 9

Re: Filament hack

Hello, ,

I have the same version , i reset with the small arduino program and no problem. 240 m , the temperature is inoperant but i change it in the gcode file. it works .
best regards

4 Reply by parentemv

  • parentemv
  • Member
  • Offline
  • Registered: 2014-12-05
  • Posts: 100

Re: Filament hack

you are using 2.1.0 firmware and filament reset works? where can I get a copy of the arduino code? What slicing software are u using?

5 Reply by db69510

  • db69510
  • Newbie
  • Offline
  • Registered: 2016-06-09
  • Posts: 9

Re: Filament hack

Hello , you have explanations here http://neoprodfx.net/flashage-cartouche … -vinci-1-x

i use slic3r and change temperature with M commands