<![CDATA[SoliForum - 3D Printing Community — Filament hack]]> https://www.soliforum.com/topic/14917/filament-hack/ Wed, 15 Jun 2016 06:19:20 +0000 PunBB <![CDATA[Re: Filament hack]]> https://www.soliforum.com/post/124172/#p124172 Hello , you have explanations here http://neoprodfx.net/flashage-cartouche … -vinci-1-x

i use slic3r and change temperature with M commands

]]> Wed, 15 Jun 2016 06:19:20 +0000 https://www.soliforum.com/post/124172/#p124172 <![CDATA[Re: Filament hack]]> https://www.soliforum.com/post/124163/#p124163 you are using 2.1.0 firmware and filament reset works? where can I get a copy of the arduino code? What slicing software are u using?

]]> Tue, 14 Jun 2016 23:27:54 +0000 https://www.soliforum.com/post/124163/#p124163 <![CDATA[Re: Filament hack]]> https://www.soliforum.com/post/124073/#p124073 Hello, ,

I have the same version , i reset with the small arduino program and no problem. 240 m , the temperature is inoperant but i change it in the gcode file. it works .
best regards

]]> Mon, 13 Jun 2016 14:52:28 +0000 https://www.soliforum.com/post/124073/#p124073 <![CDATA[Re: Filament hack]]> https://www.soliforum.com/post/123823/#p123823 Repetier, best filament hack there is !

]]> Tue, 07 Jun 2016 04:31:27 +0000 https://www.soliforum.com/post/123823/#p123823 <![CDATA[Filament hack]]> https://www.soliforum.com/post/123791/#p123791 My 1.0a has 2.1.0 firmware on it. Haven't found any info regarding filament hack for this version.

Any suggestions.

Thanks

]]> Mon, 06 Jun 2016 17:16:18 +0000 https://www.soliforum.com/post/123791/#p123791