1 Topic by CSwan

  • CSwan
  • Newbie
  • Offline
  • Registered: 2016-01-23
  • Posts: 1

Topic: sloppy prints with the WorkBench

I have been using a workbench for a while now, but I am continuously getting sloppy prints. I am using ABS filament which I have had success with in the past using a makergear M2. I don't know what my issue is, but my guess is heating. I had the best success with the extruder at 200c and bed at 100c, but the prints just arn't turning out the way I want them too. The first 10 layers are always the worst. It looks almost as if it is extruding unevenly during the first few layers but then corrects itself after a while. Any recommendations on what to adjust would be super helpful.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: sloppy prints with the WorkBench

Start with some way to apply down pressure near the Z axis guide rods.  You could even use your hand to apply slight pressure (near the rods) to ensure the bed is actually going down during layer changes.  This is a quick test that will help us determine the cause of your issues.  Unfortunately the WorkBench is plagued with many different issues that will affect print quality.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by userksh14

  • userksh14
  • Member
  • Offline
  • Registered: 2015-07-13
  • Posts: 18

Re: sloppy prints with the WorkBench

Hi, did you find anything on this? I have the same situation, first layer are really bad, it really seems is not going down, any suggestion?