1 Topic by hansen644

  • hansen644
  • Member
  • Offline
  • Registered: 2014-09-10
  • Posts: 291

Topic: Davinci 1.0 parting out. has upgraded pico b3 head

Parting out my davinci 1.0 has upgraded pico B3 head.  my main PC board went bad. Rather just make a new printer from scratch.  PM me if you want any parts thanks

2 Reply by efes (edited by efes 2015-07-07 19:58:25)

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Re: Davinci 1.0 parting out. has upgraded pico b3 head

hello, you have shaft Y davinci 1.0 ?
2x
thx

davinci 1.0
firmware repetier

3 Reply by jsntully

  • jsntully
  • Newbie
  • Offline
  • Registered: 2015-07-14
  • Posts: 1

Re: Davinci 1.0 parting out. has upgraded pico b3 head

Do you have an x axis connector?  I have a 2.0 and am not sure if it's the same piece.   I've attached a pic of what I need.

http://soliforum.com/i/?o3VhgKJ.jpg

4 Reply by wordoftheday

  • wordoftheday
  • Member
  • Offline
  • Registered: 2014-12-27
  • Posts: 14

Re: Davinci 1.0 parting out. has upgraded pico b3 head

I'm looking for a Z axis sensor.

5 Reply by techgeek

  • techgeek
  • Newbie
  • Offline
  • Registered: 2016-01-05
  • Posts: 3

Re: Davinci 1.0 parting out. has upgraded pico b3 head

Looking for the led bar (that lights up the inside)....

6 Reply by RC1

  • RC1
  • Member
  • Offline
  • Registered: 2016-01-14
  • Posts: 29

Re: Davinci 1.0 parting out. has upgraded pico b3 head

Hi there, don't suppose you still have the motherboard do you ?

Thanks

7 Reply by tommy2toes

  • tommy2toes
  • Member
  • Offline
  • Registered: 2016-03-22
  • Posts: 13

Re: Davinci 1.0 parting out. has upgraded pico b3 head

i need the front stepper motor is the one says 17pm-k142bp03cn. but not the rear of this as it is to long. they are different sizes even though they have the same numbers. so if you have this it measures 38mm length by 42 width 42 depth.  if you do have it i will take it tell me how much you want and your paypal. thanks